 |
DHS
home | People with disabilities | Publications & data |
Design for safety | Ramps and thresholds
Design
considerations in ramps and thresholds
Worksite Redesign Technical Advisory Project
- All transfer areas present potential sites for injuries to occur.
Ramps are especially dangerous because there is a change in height
as well as the potential for uncontrolled rolling. The grade allowance
should be determined based on the functional capacity of the residents
for the home. Residents in self-propelled or staff-assisted wheelchairs
require the optimum grade possible. Covering ramp areas is ideal
but
sometimes not practical. The slope should be kept as gentle as possible
-- a rise of one foot every 12 feet of ramp is ideal, while a
rise
of one foot every eight feet is the steepest grade safely negotiable.
- Provide for:
- Non-skid surfaces
- Maintenance through regular cleaning, inspection and annual
pressure-washing
- Guardrails on any elevated walking surface at 42"
- Adequate curbing for all ramps, at a minimum of four inches
- Clearance from obstructions, restrictions and/or tripping
hazards -- e.g., planter boxes, chairs, rugs, equipment, etc.
- A level landing entry outside all doors, at a minimum of
36" wide. Examine resident requirements for the
possible need of a wider landing
- Concrete surfaces rather than wooden surfaces
- Entrances must be wide enough to permit unimpeded travel. Keep
entry paths into rooms and spaces as wide as possible to avoid
trapping
situations (42" minimum, 60" ideal). Thresholds must
have as low a profile as possible to avoid walking/tripping hazards,
they can also present serious impediments to mobility of the resident
or the staff member moving the resident. Transitions from one
surface
to another, or one level to another, must be smooth and fluid.
Entryways should have straight access, and avoid corners and angled
passageways.
Return to top
Return to table of contents
- Walkway is 42" wide-60" is preferred
- Planters under the windows should be removed
- Excellent design, curb, guardrail and handrail support staff
and resident safety
|

Marigold
|
- The 60" level area at the front door allows for safe
turning, movement and side-by-side assistance
- Covered ramp with 1:12 pitch also has a level transition
to the sidewalk
- Chair should be removed from the path
- Double-acting gate allows movement in both directions
- Guardrail replaces the need for a curb
|

North A Street
|
Return to top
Return to table of contents

Washington |
- These ramps are designed for use by specific residents
- The 42" high guardrail along the edge of the ramp provides
safety for staff and residents
- The straight pathway above is a good feature. Try to avoid
turning entries; to protect users and facilitate entry
- A 48" wide ramp allows resident ambulation assistance;
a 60" width is preferred
- Inspect ramps semi-annually and maintain them with pressure-washing
and moss/mold treatments
|
|
|
Return to top
Return to table of contents
- Lighting mounted high between two doorways creates glare
and may be blinding-keep light low and diffused
- 74" wide, cement apron allows easy wheelchair access-and
side-by-side assistance to a resident
- Double door allows egress for a gurney or hospital bed in
cases of emergency
|

Adelle
|
- Glass within 12" of a door must be tempered
- Handrail must be secure
- Maintain surfaces with pressure-washing, treatment and regular
inspection
- Do not use ramps or rails for storage
|

Ruskin
|
- 44" wide doorway accommodates good wheelchair access
- Glass within 12" of a door must be tempered
- Rugs are a tripping hazard and should be replaced with beveled
walk-off mats
|

Pioneer Pike
|
- Threshold ramp smooths the transition from the exterior
door lip to interior. The ramp reduces hand force and avoids
a lifting transition
- Rugs can cause tripping and traction loss
- Ramps must be well-secured
- Doors must have tempered glass
|

Martha Court
|
Return to top
Return to table of contents

Washington |
- Ramps are designed for use by specific residents
- 42" guardrail protects staff from falling. Guardrail
along the edge of the ramp provides safety for staff
- Avoid turning entries, to protect staff and facilitate entry
for residents
- 48" wide ramp allows resident ambulation assistance-a
60" width is preferred
- Inspect ramps semi-annually and maintain them with pressure-washing
and moss/mold treatments
- Guardrails must resist 70 pounds of outward force
|
|

Bad Ramp
|

Good Ramp
|
|
|

Bad Curb
|

Good Curb
|
A 4" curb and guardrails provide protection against falls,
and improves support for medically fragile residents. |
- Inspect and maintain all ramps
- 48" wide ramp, with a 1:12 slope and 3 1/2" curb,
meets standard specifications
- Exterior illumination is provided and should be regularly
inspected
- Standard door sills are an obstruction
|

Santa Clara Avenue
|
- A ramped area with a 1:12 grade is most desirable for wheeled
devices and persons with gait disturbances. Steeper ramps
demand greater hand and arm force to maneuver the grade
- Door sills, tracks and thresholds should have the smallest
possible offset from the floor in order to prevent tripping
- 48" width of this ramp is tight for side-by-side assistance
to a walking resident-60" width is preferred
- Screen doors pose problems-outswing operation and self-closing
hinges make door an obstruction to entry
|

Firdelle
|
Return to top
Return to table of contents
- Thresholds at sliding doors are a challenge because of track
and need for exterior and interior transition
- Thresholds must be at least as wide as the door
|

Ruskin
|
- Additional sill provides traction and low profile design
- Insure that carpet used inside the door is non-skid backed
|

Santa Clara Avenue
|
Return to top
Return to table of contents
|